CJ DESIGNS AXLE PUSHER 26 MM

CJ DESIGNS AXLE PUSHER 26 MM
Click To Enlarge
  • Item #: CJD-AP-26

CJ DESIGNS AXLE PUSHER 26 MM

26 mm size fits the Super Enduro and all KTM full size dirt bikes since 2004.

This little addition to your tool kit can save you time and expensive damage to your front axle.  Don't grab a hammer and punch to drive your axle out - you can damage the threads and mar the surface. 

Thread this axle pusher into your axle and use the socket and t-handle to tap the axle out with no damage and no frustration! 

Anodized orange so you can see it in your tool kit.

In your stock KTM LC8 tool kit you should have a 10 mm socket, the same one used to loosen the fork leg end clamping the axle. Use this to thread it into the axle.  Thread it in until it fully seats at the bottom of the threads.

Push or tap on the end of your “T” handle with your hand, small rock or hammer.

This will save the axle threads from any damage caused by a punch.

The NEW 2012 verison is designed to STAY in your AXLE,  no need to remove and store it in your tool kit.   This also helps keep the threads clean from mud and grit sloshing around the length of the axle.

When you reinstall the axle, add some grease or a small amount of engine oil off your dipstick if on the trail.

Available in Orange Anodized.  MADE IN THE USA

  * Marked fields are required.
Qty*
Price $25.00

Related Items

Reviews (0) Write a Review
No Reviews. Write a Review