CJ DESIGNS AXLE PUSHER 30 MM

CJ Designs Axle Pusher
Click To Enlarge
  • Item #: CJD-AP-30

This fits most 950/990 KTM front axles: Adventure, Super Moto, Super Duke.  It will also fit the new KTM 1190 Adventure.  It does not fit the 950 Super Enduro or KTM full size dirt bikes.  See the 26 mm version in related items below for that version.

This small addition to your tool kit can help save time and expensive damage to you stock front axle.

DON'T grab that Hammer and Punch first!!

Some pullers can make your axle oval when tightened up.  This makes the axle harder to remove.

 

In your stock KTM LC8 tool kit you should have a 1omm socket, the same one used to loosen the fork leg end clamping the axle. Use this to thread it into the axle.  Thread it in until is fully seats at the bottom of the threads.

 

Push or tap on the end of your “T” handle with your hand, small rock or hammer.

 

This will save the axle threads from any damage caused by a punch.

 

The NEW 2012 verison is designed to STAY in your AXLE,  no need to remove and store it in your tool kit.   This also helps keep the threads clean from mud and grit sloshing around the length of the axle.

 

When you reinstall the axle, add some grease or a small amount of engine oil off your dipstick if on the trail.

 

Available in Orange Anodized.  MADE IN THE USA


  * Marked fields are required.
Qty*
Price $25.00

Other Items You May Be Interested In

Related Items

Reviews (0) Write a Review
No Reviews. Write a Review